While hand-holding the camera, pressing the rocker switch to the
right provides camera run, pressing the switch to the left provides
test. Unlike the body switch, the camera test position of the hand-
grip is a momentary switch. Pressing and holding the switch opens
the shutter and advances the mechanism 1/2 frame. Pressing and
immediately releasing this switch advances the mechanism one full
frame at a 1/4 sec exposure time. This function allows the use of the
handrip as a simple intervalometer.
4.2.3 Handgrip Adjustment
The handgrip rotation should be adjusted for maximum handheld
operating comfort. Loosen the T screw and rotate the handgrip at
the star plate until a more comfortable position is found. If a more
extreme repositioning is required, whether it be for reasons of com-
fort or clearance in certain studio rig configurations, this can be
achieved with coupler extenders, spacers and intermediate arms whi-
ch utilize the star plate system for adjustment. Ask your agent for a
configuration that meets your needs
4.3 TRIPOD USE
In order to use the AATON 35-III on a standard tripod, the tripod’s
quick release plate must be fastened to the underside of the camera
body with its standard 3/8-16 screw. Make sure to use only a quick
release plate screw provided by the manufacturer; non standard
screws longer than 8mm (1/3’’) can fracture the base casting and
damage the camera’s electronics.
4.4 SHOULDER OPERATION
One of the most attractive features of the Aaton system has always
been its comfort and ease of use in handheld situations.
The AATON 35-III does not require the use of shoulder braces or
56
To Next Page
Loading...