If the IED has damaged during transportation, make a claim against the transport
contractor, and notify the local ABB representative.
3.2.4
Returning an IED damaged in transit
If damage has occurred during transport, appropriate actions must be taken against the
latest carrier. Please inform the nearest ABB office or representative. ABB should be
notified immediately if there are any discrepancies in relation to the delivery documents.
3.3 Storing
If the IED is stored before installation, it must be done in the original transport casing
in a dry and dust free place in accordance with ANSI C37.90.0. Observe the
environmental requirements stated in the technical manual.
Section 3 1MAC051065-MB C
Unpacking, inspecting and storing
12 615 series ANSI
Installation Manual
To Next Page
Loading...
