ABB 615 Series - Semi-Flush Mounting the IED Inclined

B
A
C
D
E
A070591 V2 EN
Figure 9: Semi-flush mounted IED
A 7.32 inches (186 mm)
B 6.97 inches (177 mm)
C 7.64 inches (194 mm)
D 4.06 inches (103 mm)
E 3.58 inches (91 mm)
4.3.3 Semi-flush mounting the IED inclined
A mounting kit is needed for semi-flush mounting the IED inclined. In addition to the
detailed mounting instructions, the mounting kit includes:
•
Angle frame
• Gasket
• Screws
Requirements for installation:
• Panel cut-out of 6.57 x 7.99 inches (167 x 203 mm) with mounting holes
• Depth behind the panel 4.21 inches (107 mm)
• When IP 54 degree of protection (according to IEC 60529) is required for the front
side, a gasket has to be used in the installation.
Section 4 1MAC051065-MB C
Mounting
22 615 series ANSI
Installation Manual