Section 6 Removing, repairing and exchanging
6.1
Product lifecycle
In the product lifecycle, there is going to be a time to upgrade the IED to a next
generation unit. Although this is not relevant until some 20 years after the installation,
it is wise to already consider the product lifecycle when investing on the original product.
IED-specific options can be found from Retrofit Solutions Database on the Internet
www.abb.com by following the links within ABB Service Guide or via ABB Product
Guide from the product specific Service & Support sheet.
6.2
Checking IED information
The IED information includes detailed information about the device, such as version
and serial number. The IED information is shown on the display for a few seconds
when the device starts up. The same information is found also in the IED menu.
1. Select Main Menu/Information.
2. Select a submenu with
and .
3.
Enter the selected submenu with
.
4.
Browse the information with
and .
The Product identifiers submenu contains product related information like product
type, serial number, order number, production date, configuration name, SW version,
SW date and HW revision.
The Site identifiers submenu contains information about the site where the IED has
been installed.
The HW modules submenu contains information about the HW modules.
The System identifiers submenu contains the unique Technical key which cannot be
changed.
1MAC051065-MB C Section 6
Removing, repairing and exchanging
615 series ANSI 41
Installation Manual
To Next Page
Loading...
