5.5 Connecting power supply
The IED's auxiliary voltage is connected to terminals X100-1 and X100-2. The positive
lead is connected to terminal X100-1. The permitted auxiliary voltage range of the IED
is marked on top of the IED's LHMI.
A070770-ANSI V1 EN
Figure 24: Connecting auxiliary voltage
5.6 Connecting communication
Before connecting communication, check that the HW module has the correct
communication interfaces. The communication module is located on the left side of the
IED when viewing the case from the rear.
See the technical manual for product-specific communication interfaces.
Section 5 1MAC051065-MB C
Connecting
38 615 series ANSI
Installation Manual
To Next Page
Loading...
