Technical data
110
Materials
Drive enclosure • PC/ABS 2.5 mm, colour NCS 1502-Y (RAL 90021 / PMS 420 C)
• hot-dip zinc coated steel sheet 1.5 to 2 mm, thickness of coating 100 micrometres
• cast aluminium AlSi (R2 and R3)
• extruded aluminium AlSi (R4 to R6)
Package Corrugated cardboard (frames R2 to R5 and option modules), plywood and wood (frame
size R6), expanded polystyrene. Plastic covering of the package: PE-LD, bands PP or
steel.
Disposal The drive contains raw materials that should be recycled to preserve energy and natural
resources. The package materials are environmentally compatible and recyclable. All
metal parts can be recycled. The plastic parts can either be recycled or burned under
controlled circumstances, according to local regulations. Most recyclable parts are marked
with recycling marks.
If recycling is not feasible, all parts excluding electrolytic capacitors and printed circuit
boards can be landfilled. The DC capacitors (C1-1 to C1-x) contain electrolyte and the
printed circuit boards contain lead, both of which are classified as hazardous waste within
the EU. They must be removed and handled according to local regulations.
For further information on environmental aspects and more detailed recycling instructions,
please contact your local ABB distributor.
Applicable standards
The drive complies with the following standards. The compliance with the European Low
Voltage Directive is verified according to standards EN 61800-5-1 and EN 60204-1.
• EN 60204-1 (2006) Safety of machinery. Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is responsible for installing
- an emergency-stop device
- a supply disconnecting device
- the ACS800-04/U4 into a cabinet.
• EN 60529: 1991
(IEC 60529)
Degrees of protection provided by enclosures (IP code)
• IEC 60664-1 (2007) Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests.
• EN 61800-3 (2004) Adjustable speed electrical power drive systems. Part 3: EMC requirements and specific
test methods
• EN 61800-5-1 (2003) Adjustable speed electrical power drive systems. Part 5-1: Safety requirements –
electrical, thermal and energy
• UL 508C (2002) UL Standard for Safety, Power Conversion Equipment, second edition
• NEMA 250 (2003) Enclosures for Electrical Equipment (1000 Volts Maximum)
• CSA C22.2 No. 14-05
(2005)
Industrial control equipment
To Next Page
Loading...
