Electrical installation
67
Connecting the control cables
Connect the control cables as described below. Connect the conductors to the
appropriate detachable terminals of the RMIO board [see chapter Motor control and
I/O board (RMIO)]. Tighten the screws to secure the connection.
Terminals
Location of terminals vary depending on the drive frame size.
Detachable connection terminals (pull up)
Optional module 1
Optional module 2
Frame sizes R2 to R4
The control cable connection terminals are
exposed when the control panel mounting platform
is turned aside by pulling this knob. Be careful, do
not use excess force when pulling.
(control panel is an option)
X39 for control panel cable
Place the warning
sticker here
DDCS communication
option module 3:
RDCO
Relay outputs
1
2
3
4
X41
Terminal for optional
Prevention of Unexpected
Start
I/O cables: Ground the
control cable shields in the
holes with screws. See
section 360 degrees
grounding.
To Next Page
Loading...
