Planning the cabinet assembly
32
Cabinet heaters
Use a cabinet heater if there is a risk of condensation in the cabinet. Although the
primary function of the heater is to keep the air dry, it may also be required for
heating at low temperatures. When placing the heater, follow the instructions
provided by its manufacturer.
Mounting the optional control panel
The optional control panel CDP312R is factory assembled on the drive module.The
panel can also be fastened directly to the cabinet door or to a mounting platform.
Installing the control panel directly on the cabinet door
Fasten the control panel from the back side with two screws of one of the following
types:
• standard screw with nominal diameter of 4 mm (0.16 in.)
• tapping screw with nominal diameter of 4.2 mm (0.17 in.) DIN 7981 C, DIN 7982
C, DIN 7983 C or DIN 7976 C
• PT screw for thermoplastics with nominal diameter of 4 mm (0.16 in.).
Control panel
Cabinet door
Tightening torque:
1 Nm (0.74 lbf ft)
4...8 mm
(0.16...0.31 in.)
10 mm (0.39 in.)
View from outside the cabinet door
Control panel footprint
To Next Page
Loading...
