ABB ACS880 - 2 Quick Start-Up Guide; Contents of this Chapter; Before You Start; Safety

Quick start-up guide 11
2
Quick start-up guide
Contents of this chapter
This chapter contains the basic start-up procedure of the ACS880 IGBT based slip
power recovery system.
Before you start
Make sure the drive is mechanically and electrically installed as described in the
appropriate Quick installation guide and/or Hardware manual.
Safety
WARNING! All electrical installation and maintenance work on the drive must
be carried out by qualified electricians only.
Never work on the drive, the brake chopper circuit, the motor cable or the motor when
power is applied to the drive. Always make sure by measuring that no voltage is
actually present.
WARNING! Make sure that the machinery into which the drive with the
Override control program is integrated fulfills the personnel safety regulations.
Note that the frequency converter (a Complete Drive Module or a Basic Drive
Module, as defined in IEC 61800-2 with the Override control program), is not
considered as a safety device mentioned in the European Machinery Directive and
related harmonized standards. Thus, the personnel safety of the complete machinery
must not be based on a specific frequency converter feature (such as the Override
control program), but it has to be implemented as defined in the application specific
regulations.