Fault tracing 45
Fault tracing
Contents of this chapter
This chapter lists the warning and fault messages (including possible causes and
corrective actions) which differ from ACS880 primary control program described in
ACS880 primary control program firmware manual [3AUA0000085967 (English)].
WARNING! Only qualified electricians are allowed to service the drive. Read
the Safety instructions on the first pages of the hardware manual for the single
drives, or in the Safety instructions [3AUA0000102301 (English)] for the
multidrives and multidrives modules before working on the drive.
Indications
Warnings and faults
A warning or fault message on the panel display indicates abnormal drive status.
Most of the warnings and faults causes can be identified and corrected using this
information. If not, contact your local ABB representative.
If the drive is operated with the control panel detached, the red LED in the panel
mounting platform indicates the fault condition. Note that some drive types are not
fitted with LEDs as standard.
The four-digit code number in parenthesis after the fault is for the fieldbus
communication.
To Next Page
Loading...
