ABB ACS880 - Warning Messages

Fault tracing 49
Warning messages
E200 SPRS
Contactor not
close
K1 contactor failed to switch on. • Monitor the parameter
74.01 ACK SPRS
contactor on, the DI
assigned to detect
feedback from K1
contactor.
• Check the circuit
connected to the chosen
DI for faults
Code Fault Cause What to do
D200 Grr contactor
not open
K2 contactor failed to switch off. • Monitor the parameter
74.02 ACK G/LRR
contactor on, the DI
assigned to detect
feedback from K2
contactor.
• Check the circuit
connected to the chosen
DI for faults.
D202 Tacho feedback
fail
Tachometer feedback failed. • See parameters 77.02
Tacho feedback
selection and 77.04
Rotor voltage feedback.
• Check the connections
for the chosen AI for both
parameters.
D203 SPRS Ready SPRS system indication while
in GRR mode.
Can safely changeover
from GRR to SPRS system
without any problems.
Code Fault Cause What to do