34 Parameters
Terms and abbreviations
Summary of parameter groups
Term Definition
Actual signal Type of Parameter that is the result of a measurement or calculation by
the drive, or contains status information. Most actual signals are read-
only, but some (especially counter-type actual signals) can be reset.
Def (In the following table, shown on the same row as the parameter name)
The default value of a Parameter.
Note: Certain drive hardware or optional equipment may require different
default values.
FbEq16 (In the following table, shown on the same row as the parameter range,
or for each selection)
16-bit fieldbus equivalent: The scaling between the value shown on the
panel and the integer used in communication when a 16-bit value is
selected for transmission to an external system.
A dash (-) indicates that the parameter is not accessible in 16-bit format.
Other The value is taken from another parameter.
Choosing “Other” displays a parameter list in which the user can specify
the source parameter.
Other [bit] The value is taken from a specific bit in another parameter.
Choosing “Other” displays a parameter list in which the user can specify
the source parameter and bit.
Parameter Either a user-adjustable operating instruction for the drive, or an Actual
signal.
p.u. Per unit
Group Contents Page
09 SPRS actual signals Signals for monitoring SPRS operation. 35
14 I/O extension module 1 Configuration of I/O extension module 1 for SPRS. 38
15 I/O extension module 2 Configuration of I/O extension module 2 for SPRS. 38
74 SPRS DI Defines SPRS digital inputs. 38
75 SPRS User values User values for SPRS. 40
76 SPRS relay outputs Status information indicated through the relay outputs and the
relay operating delays for SPRS.
40
77 Speed and Feedback SEL Analog inputs for SPRS. 41
78 SPRS Limits Speed limits for SPRS. 42
To Next Page
Loading...
