ControlMaster CM30 and CM50
Universal process controllers,
1
/4 and
1
/2 DIN 7 Advanced Level
58 IM/CM/ED–EN Rev. B
7.8 Communication
…Functions
Real Time Alarms 2 Independent real-time alarms can be configured to be activated on particular days and
times for a set duration.
Real Time Alarm 1
(2)
Sets the days the alarm is activated, the alarm duration, alarm display enable in the
diagnostics window and enables a (status bar) tag to be created for the alarm.
Monday (to Sunday)
Month enable
When enabled (On), activates the alarm on the 1
st
day of each month.
Every hour
When enabled (On), activates the alarm every hour.
On hour
Sets the hour the alarm is activated – not applicable if Every Hour is set to On.
On minute
Set the minutes past the hour the alarm is activated.
Duration
Set the duration the alarm is active.
Display enable
If disabled (Off), the alarm state does not appear in the operator level diagnostics window or
the alarm log.
Tag
A 16-character alphanumeric tag displayed as a diagnostic message that appears in the
Diagnostic Status Bar and in the Operator Level, Diagnostic View – see page
16.
Used to setup communications parameters for the (optional) MODBUS /
Ethernet communication protocols – see separate User Guide (IM/CM/C-EN).
Note. Only one communications option can be fitted per controller.
Menu
Communication
Exit
Select
To Next Page
Loading...
