19
8 COMMUNICATION…
8.6.2 Profile Parameters
Parameter
Mnemonic
Command
Reply Interpretation
Read
(R)
Write
(W)
Profile Parameters
Profile Status PS Yes No 0 = Stop
1 = Ramp
2 = Soak
3 = Not Used
4 = Countdown
5 = Operator Hold
6 = Not Used
7 = Manual Hold
8 = Holdback Hold
9 = End
Countdown Time CD Yes No Time (in Minutes)
Current Programme PP Yes No 1 to 9
Current Segment PG Yes No 0 to 30
Segment Time PT Yes No Time (in Minutes)
Prog. Repeat Count PR Yes No 0 to 99 (100 = Always)
First Prog. Select 1P Yes Yes 1 to 9 (10 = None)
Second Prog. Select 2P Yes Yes 1 to 9 (10 = None)
Third Prog. Select 3P Yes Yes 1 to 9 (10 = None)
Fourth Prog. Select 4P Yes Yes 1 to 9 (10 = None)
Time Delay TD Yes Yes 0.0 to 999.9 minutes
Profile Start GP Yes Yes 1 = Start
Hold State
PH Yes No Bit 0 = Operator Hold
Bit 2 = Manual Mode Hold
Bit 3 = Holdback Hold
Profile Reset
RT Yes Yes 1 = Reset Profile
Skip
PK Yes Yes 1 = Skip
Operator Hold
PO Yes Yes
1 = Operator Hold
To Next Page
Loading...
