17
www.abb.com/lowvoltage 2TLC172015M0201, rev. D
4.3 Setting up of Internal Change-Over Switches Transmitter
• Disconnect the power supply to the unit and open the small lid in the bottom cap (with the M12 con-
nector) so that the two change-over switches become visible.
• The change-over switches may be adjusted to the desirable position with a small, suitable screwdri-
ver.
NB! Make sure to always set switches in both banks to the same position.
Switch position Setting Function
1
OFF
Range setting
X
ON Short range
2
OFF
Range setting
X
ON Long range
3
OFF
Code setting
No coding
ON Coding
4
OFF
Code setting
Code A
ON Code B
Selector switches 5 - 8 are not used in the transmitter.
Switch 1 Switch 2 Range selected
OFF OFF Not allowed
OFF ON Long range
ON OFF Short range
ON ON Not allowed
Please refer to the table below for the range setting:
1 2 3 4 5 6 7 8
OFF
ON
1 2 3 4 5 6 7 8
OFF
ON
Default setting, 5-8 not used.
Switch no. 1 in ON position
To Next Page
Loading...