must be respected) and pull the display housing from the
communication board. Reposition the display connector
according to the preferred position. Push the display module
back onto the communication board. Ensure the plastic fixing
locks are in place.
Securing the housing in flame-proof areas
Each of the front faces of the electronics housing features a
locking screw (hex-head socket screw) on the bottom side.
• Install the housing cover to the housing by hand-tightening it.
• Turn the locking screw counterclockwise to secure the
housing cover. This involves unscrewing the screw until the
screw head stops at the housing cover.
To Next Page
Loading...
