7
Use of instruction
DANGER - Serious damage to health / risk to life
This symbol in conjunction with the signal word “DANGER”
indicates an imminent electrical hazard. Failure to observe
this safety information will result in death or severe injury.
WARNING - Bodily injury
This symbol in conjunction with the signal word “WARNING”
indicates a potentially dangerous situation. Failure to observe
this safety information may result in death or severe injury.
CAUTION - Minor Injuries
This symbol in conjunction with the signal word “CAUTION”
indicates a potentially dangerous situation. Failure to observe
this safety information may result in minor or moderate injury.
This symbol may also be used for property damage warnings.
NOTICE - Property Damage
This symbol indicates a potentially damaging situation.
Failure to observe this safety information may result in
damage to or destruction of the product and / or other
system components.
IMPORTANT (NOTE)
This symbol indicates operator tips, particularly useful
information or important information about the product or its
further uses. The signal word “IMPORTANT (NOTE)” does not
indicate a dangerous or harmful situation.
Operator liability
In instances where corrosive and / or abrasive materials are
being measured, the user must check the level of resistance of
all parts that are coming into contact with these materials. ABB
offers guidance in the selection of material but does not accept
liability in performing this service. The user must strictly
observe the applicable national regulations with regards to
installing, functional testing, repairing and maintaining
electrical devices.
Qualified personnel
Installing, commissioning and maintaining the device may be
performed only by trained personnel who are authorized by the
plant operator. These trained personnel must have read and
understood this manual and must comply with its instructions.
Returning devices
For the purpose of returning the device for repair or
recalibration, use the original packaging or other suitably
secure shipping method. The sender should contact the factory
for return authorization number and fill out return form
(provided at the end of the manual) and include it with the
device. According to C guidelines other local laws for hazardous
materials, the owner of the corresponding hazardous waste is
responsible for its disposal. The owner must observe the
proper regulations for shipping purposes. All devices returned
to ABB must be free of any hazardous materials (for example,
acids, alkalis and solvents).
Disposal
ABB actively promotes environmental awareness and has an
operational management system that meets the requirements
of DIN EN ISO 9001:2000, EN ISO 14001:2004 and OHSAS
18001. ABB products are intended to have minimal impact on
the environment and individuals during their manufacture,
storage, transport, use and disposal.
This adherence to environmental standards includes the use
of natural resources. In this endeavor, ABB maintains an open
dialog with the public through its publications.
The product / solution is manufactured from materials that can
be reused by specialized recycling companies.
Information on WEEE Directive 2002/96/EC
(Waste Electrical and Electronic Equipment)
Note : Starting from August 15
th
2018, electrical
and electronic equipment marked with the
crossed-out wheeled bin symbol may not be
disposed as unsorted municipal waste. Waste
of electrical and electronic equipment (WEEE)
shall be treated separately using the national
collection framework available to customers for the return,
recycling and treatment of WEEE.
Bear the following points in mind when disposing of them:
• As of 8/15/2018, this product will be under the open scope of
the WEEE Directive 2012/19/EU and relevant national laws (for
example, ElektroG - Electrical Equipment Act - in Germany).
• The product must be supplied to a specialist recycling
company. Do not use municipal waste collection points. These
may be used for privately used products only in accordance
with WEEE Directive 2012/19/EU.
Safety information for electrical installation
WARNING - Bodily injury.
Electrical connections may only be established by
authorized personnel in accordance with the electrical
circuit diagrams. The electrical connection information in
the manual must be observed; otherwise, the application
protection type may be affected. Ground the measurement
system according to requirements.
To Next Page
Loading...
