STEP 3:
Press
or to navigate to the Diagnostic menu
Press “Select”
to enter the menu
STEP 4:
Press
or to get to “Waveform” menu
Press “Select”
to enter the menu
STEP 5:
Press
or to get to the desired position of the
waveform
Press “Select”
to enter the waveform screen
IMPORTANT NOTE
• At Sensor Ref Pt. displays the signal starting from the
beginning of the probe, which is the same as from the
enclosure down.
• “At Level” displays the signal with the Level position centered
in the screen, unless other limit factors apply but in any case
the level position should be visible in the screen.
• “At Distance” displays the signal starting from the distance
specified by the user. The Level position must be centered in
the screen, unless other limit factors apply but in any case the
level position should be visible in the screen.
• “End of Probe” displays the signal the tip of the probe.
Review or Edit device measurement parameters
THRESHOLD:
Press
to scroll the cursor to the device measurement
parameters.
Press
or keys to select THD (threshold).
Press
to edit the threshold value.
Press
to scroll from one digit to another
Press
or keys to edit each digit.
Press
to complete this operation and OK/accept the input
value.
PULSE WIDTH:
Press
and keys to select PLS (pulse width).
Press
to edit the PLS value.
Press
to scroll from one digit to another
Press
or keys to edit each digit.
Press
to complete this operation and OK/accept the input
value.
BLANKING / BLOCKING DISTANCE:
Press
or keys to select BLK (Blanking Distance).
Press
to edit the BLK value.
Press
to scroll from one digit to another
Press
or keys to edit each digit.
Press
to complete this operation and OK/accept the input
value.
To Next Page
Loading...
