30 M4M 20 NETWORK ANALYZER USER MANUAL
7.First commissioning
At first power up of M4M network analyzers, wizard procedure will guide the user in the first
commissioning steps:
1. Set the language (please refer to chapter “7.1.Setting language”)
2. Set a password (please refer to chapter “7.2.Password for the first use”)
3. Set the date and time on the device (please refer to chapter “7.3.Date and time”)
4. Set the type of network (please refer to chapter “7.4.Type of network”)
5. Set the CT ratio (please refer to chapter “7.5.CT ratio”)
6. Set the VT ratio (please refer to chapter “7.6.VT ratio”)
7. M4M 20-M (MID): Set the Lock (please refer to chapter “7.7.Lock MID version”)
7.1.Setting language
It is possible to change the display language to one of the languages present in the device.
→
→
Unit
→
Language
1. Use to scroll the list on of values or fields.
2. Press
ENTER
to confirm or
BACK
to cancel the modification.
7.2.Password for the first use
A password can be set by the user to protect the Configuration menu and avoid any unwanted
modification to the device settings.
1. At the first use it is mandatory to define a
password. The password is composed by 5
numerical characters.
2. In order to select each numerical character, it
is necessary to use .
3. Press
ENTER
to confirm or
BACK
to cancel the
modification.
In order to disable the password, please set the new password as 00000.
The password can be changed in any moment in Configurations -> Unit -> Modify password (please refer to
chapter “8.1.Unit”).
M4M 20-M (MID): It is not possible to disable password. Password only protects non-critical configurations.
Critical configurations are protected by Lock (please refer to chapter
“7.7.Lock MID version”
)
2
3
To Next Page
Loading...
