ABB M4M 20 - Date and Time; Type of Network

M4M 20 NETWORK ANALYZER USER MANUAL
31
7.3.Date and time
Setting date and time is mandatory in order to use the time-related functionalities on the device (e.g. Maximum,
Minimum). Please notice that if no date and time are set, no timestamp will be available on the measured data.
→ → Unit → Date/Time
Date/Time
Set Date
Set Time
Menu Description
Set date Configure the current date with format YYYY/MM/DD.
Set time Configure the current time.
When M4M 20 is turned off, the date and time are reset. After turning on the M4M 20 network analyzer, please
configure date and time.
7.4.Type of network
In order to configure the type of network it is needed to choose one of the available options according to
the installation conditions.
MID compliant networks are market with M on the display.
→ → Installation → Type of network
3Ph/4W/3CT
3Ph/3W/3CT
3Ph/3W/2CT
3Ph/3W/1CT
1. Use to scroll the list on of values or
fields.
2. Press
ENTER
to confirm or
BACK
to cancel the
modification.
According to the type of network that has been chosen, the parameters visualized on the device HMI
change. Please see below the table with details:
Option Description Option Description
3Ph/4W/3CT 3-phase 4-wire + 3CTs 3Ph/3W/2CT 3-phase 3-wire + 2CTs
3Ph/4W/1CT 3-phase 4-wire + 1CT 2Ph/3W/2CT 2-phase 3-wire + 2CTs
3Ph/3W/1CT 3-phase 3-wire + 1CT 1Ph/2W/1CT 1-phase 2-wire + 1CT
3Ph/3W/3CT 3-phase 3-wire + 3CTs
1
2