ABB PGS100 User Manual

2 PGS100 AND PAS100 | PRESSURE TRANSMITTERS | OI/PGS/PAS100-EN REV. A
Contents
1 Safety ..................................... 4
General safety information. . . . . . . . . . . . . . . . . . . . . . . . . 4
Improper use ...................................... 4
Technical limit values .............................. 4
Warranty provision ................................ 4
Use of instruction ................................. 4
Operator liability ...................................5
Qualified personnel ................................5
Returning devices ..................................5
Disposal ...........................................5
Information on WEEE Directive 2012/19/EU
(Waste Electrical and Electronic Equipment) .........5
Transport and storage ..............................5
Safety information for electrical installation .........5
Safety information for inspection and maintenance . 6
Cyber security .................................... 6
Disclaimer....................................6
Communication protocol specific..............6
2 Transmitter overview ........................7
Transmitter components overview ..................7
Range and span consideration ......................7
3 Opening the box .............................8
Identification plates ............................... 8
Optional wired-on plate ........................... 8
Handling and storage .............................. 9
4 Mounting ...................................9
General ........................................... 9
IP protection and designation ......................10
Mounting the transmitter ..........................10
Transmitter factory configuration
consideration ...............................10
Hazardous area considerations...............10
Pressure Equipment Directive (PED)
(2014/68/EU) .....................................10
Devices with PS >200 ........................10
Devices with PS ≤ 200 ........................10
Mounting a P style pressure transmitter ............11
Sealing and screw connections .....................11
Moisture ..........................................11
Measuring pipe ...................................12
5 Transmitter wiring..........................13
Supply requirement ...............................13
Cable connection ..................................13
Wiring procedure ..................................14
Grounding ........................................14
Output (HART) transmitter wiring ..................15
Communication setup .............................15
6 Commissioning .............................16
General remarks ...................................16
Output signal .....................................16
Output current limits for analog only version ..16
Output current limits for HART and analog
version (according to NAMUR NE 43 standard). 16
Zero/Span and write protection ....................16
Local display ......................................17
Adjusting lower range value / oblique sensors ......18
Installing/Removing the LCD display ...............19
Pressure sensor ventilation (PGS100 only) ......... 20

ABB PGS100 Specifications

General

Brand	ABB
Model	PGS100
Category	Transmitter
Language	English