ABB | E-kit
22 | © 2022 ABB | - 1SDH002203A1002 Web interface configuration
1. Change the name of the device;
2. Add the device to the system by selecting Yes on a level with Device Used;
3. Select whether the device is connected in in Modbus TCP/IP or RTU;
4. Set a template from the pull-down menu accessed by clicking on the grey bar with the words No
Template; The Vendor and Model fields will be automatically populated once a template has been
selected;
5. Select the correct Vendor from the corresponding pull-down menu;
6. Select the required model from the pull-down menu ;
7. The Unit ID parameter is 1 by default;
8. Enter the IP address of the device;
9. The TCP Port parameter is 502 by default;
10. Quit the window without performing any action (Cancel button);
11. Restore the default values of all the channels (Save & Initialize button);
12. Save the model configuration and upload the changes made to the focus (Save & Reload button).
13. If the device is connected in Modbus RTU network, the UnitID, IP Address and TCP Port properties are
replaced by Slave, with default value 1, enabling the address of the device to be entered, as shown in
the next figure.
To Next Page
Loading...
