FEP630, FEH630 ELECTROMAGNETIC FLOWMETER | OI/FEP630/FEH630-EN REV. D 149
Tightening torques for transducers with design level ‘B’
Note
The specified torques are valid only for greased threads and piping that is not subject to tensile stress.
Nominal diameter [mm (in)]
Pressure rating Hard / soft rubber PTFE
** [Nm] *** [Nm] ** [Nm] *** [Nm]
DN 25 (1 in) PN40 — — 13.32 8.6
CL150 — — 23.98 23.98
CL300 — — 65.98 38.91
JIS 10K — — 26.94 26.94
DN 32 (1 ¼ in) PN40 — — 45.08 45.08
CL150 — — 29.44 29.44
CL300 — — 45.52 45.52
JIS 10K — — 45.08 45.08
DN 40 (1 ½ in) PN40 — — 56.06 56.06
CL150 — — 36.12 36.12
CL300 — — 73.99 73.99
JIS 10K — — 56.06 56.06
DN 50 (1 ½ in) PN40 — — 71.45 71.45
CL150 — — 66.22 66.22
CL300 — — 38.46 38.46
JIS 10K — — 71.45 71.45
DN 65 (2 ½ in) PN16 — — 37.02 39.1
PN40 — — 43.03 44.62
CL150 — — 89.93 89.93
CL300 — — 61.21 61.21
JIS 10K — — 37.02 39.1
DN 80 (3 in) PN40 — — 51.9 53.59
CL150 — — 104.6 104.6
CL300 — — 75.54 75.54
JIS 10K — — 45.07 47.16
DN 100 (4 in) PN16 — — 49.68 78.19
PN40 — — 78.24 78.19
CL150 — — 76.2 76.2
CL300 — — 102.6 102.6
JIS 10K — — 49.68 78.19
DN 125 (5 in) PN16 — — 61.4 64.14
PN40 — — 123.7 109.6
CL150 — — 98.05 98.05
CL300 — — 139.4 139.4
DN 150 (6 in) PN16 — — 81.23 85.08
PN40 — — 162.5 133.5
CL300 — — 111.4 111.4
** Flange material: steel.
*** Flange material: stainless steel.
To Next Page
Loading...
