ABB ProcessMaster FET632 - Menu: Device Setup

81
FEM630 | ELECTROMAGNETIC FLOWMETER | OI/FEM630-EN REV. A
Menu / parameter
Device Setup
...Access Control
Selection of submenu ‘...Access Control’ using .
...Sensor
Selection of submenu ‘...Sensor’ using .
...Transmitter
Selection of submenu ‘...Transmitter’ using .
Device Setup / ...Sensor
Range Mode Config
Activation of the second measuring range for the mass and volume flow.
The setting can be performed separately for the mass flow rate (Qm) and volume flow (Qv). Thus you have the

performed via the parameters ‘Qm Range Mode’ and ‘Qv Range Mode’.
• Disabled: Second measuring range for mass and volume flow rate deactivated.
• Qm and Qv: Second measuring range for mass and volume flow rate activated.
• Qm only: Second measuring range for mass flow activated.
• Qv only: Second measuring range for volume flow activated.
Default setting: Disabled
Qm Max DN

The value is automatically set through the selected nominal diameter, multiplied by the set density.


reverse flow .

max
DN


reverse flow .

Mode’.
Qm Range Mode

measurement. This parameter is only available if the value Qm and Qv or Range Mode Config has been selected
for the parameter ‘Qm only’.
Device Setup / ...Access Control
Standard Password Entry / change of the password for the ‘Standard’ access level.
Read Only Switch
Indicator of the position of the write protection switch.
For additional information, see Hardware settings
8 ...Operation
...Parameter descriptions
Menu: Device Setup