ABB ProcessMaster FET632 - Page 99

99
FEM630 | ELECTROMAGNETIC FLOWMETER | OI/FEM630-EN REV. A
Diagnostics / ...Diagnosis Control / ...Diagnosis Conductiv*
Conductivity On/Off
Activate the conductivity diagnostic function.
Default setting: Off
Note

For additional information, see Extended diagnostic functions
 
Adj. Cond. Value
Conductivity must be set in accordance with the conditions on-site.
Measure the conductivity using a conductivity meter on-site and enter the measured value here.

Cond. Iout Min Value 
Cond. Iout Max Value 
Cond.Min Alarm Value Set the alarm for minimum and maximum conductivity. In the case of down-scale, an alarm is triggered.
Cond.Max Alarm Value 






Diagnostics / ...Diagnosis Control / ...Diagnosis SIL**
SIL On/Off
For information purposes only.
SIL devices are delivered ex works as SIL devices. There is no special SIL mode to activate
8 ...Operation
...Parameter descriptions
* The menu is only available if the Expert Diagnosis function is activated. See also the ‘Device Setup\...Transmitter\...Feature Settings’ menu.
** Menu only available if SIL diagnostic function is activated. See also the ‘Device Setup\...Transmitter\...Feature Settings’ menu.