11Introduction and general information
EN
2. Introduction and general information
2.1 Warranty and supply conditions
The warranty conditions (available on the official ABB website) are considered to be valid if the Customer
adheres to all indications content in this manual; any condition deviating from those described herein
must be expressly agreed in the purchase order.
NOTE – D ABB declares that the equipment complies with the provisions of law currently in force
in the country of installation and has issued the corresponding declaration of conformity.
2.1.1 Not included in the supply conditions
ABB will NOT be held liable for defects or malfunctions arising from:
• improper use of the equipment;
• deterioration resulting from transportation or particular environmental conditions;
• performing maintenance incorrectly or not at all;
• tampering or unsafe repairs;
• use or installation by unqualified persons.
ABB is not responsible for disposal of the equipment, or part of it, which does not take place on the basis
of the regulations and laws in force in the country of installation.
ATTENTION – A ABB accepts no liability for failure to comply with the instructions for a correct
installation and will not be held responsible for systems upstream or downstream of the
equipment it has supplied.
FORBIDDEN – H It is absolutely forbidden to modify the equipment. Any modification,
manipulation, or alteration not expressly agreed with the manufacturer, concerning either
hardware or software, shall result in the immediate cancellation of the warranty.
NOTE – D The customer is fully responsible for any changes made to the system.
To Next Page
Loading...
Need help?
General