61Installation
EN
• Install the protective earth cable lug (31) to the protection earth connection point (36) situated on the
internal bottom side of power module.
36
31
Use the washers and bolt supplied in the power module installation kit:
1 = toothed washer
2 = cable lug
3 = toothed washer
4 = M5 nut
1
2
3
ATTENTION – A The cable lug must be installed with a tightening torque of 3Nm (2.2 ft-lb).
ATTENTION – A Any failure of the inverter when it is not connected to earth through the
appropriate connection point is not covered by the warranty.
To Next Page
Loading...
