16
Terminal identification rated and base values Chapter 2
General
1 Terminal identification rated and base values
1.1 General terminal parameters
Use the terminal identifiers to name the individual terminal for identification purposes. Use the
terminal reports to check serial numbers of the terminal and installed modules and to check the
firmware version.
Identifiers and reports are accessible by using the HMI as well as by SMS or SCS systems.
Path in local HMI: Configurations/Identifiers
Table 4: Set parameters for the general terminal parameters function
1.2 Basic protection parameters
Path in local HMI: Configuration/AnalogInputs/General
Table 5: Setting parameters for Analog Inputs - General
Path in local HMI: Configuration/AnalogInputs/TrafoinpModule
Parameter Range Default Unit Description
Station Name 0-16 Station Name char Identity name for the station
Station No 0-99999 0 - Identity number for the station
Object Name 0-16 Object Name char Identity name for the protected object
Object No 0-99999 0 - Identity number for the protected object
Unit Name 0-16 Unit Name char Identity name for the terminal
Unit No 0-99999 0 - Identity number for the terminal
Parameter Range Default Unit Description
CTEarth In/Out Out - CT earthing location
In = bus side
Out = line side
fr 50, 60, 16 2/3 50 Hz System frequency
To Next Page
Loading...
