ABB REL 551-C1*2.5 - Input and Output Signals; Setting Parameters

To Next Page

To Previous Page

Event function (EV) Chapter 7

Logic

2.4 Input and output signals

Table 101: Input signals for the EVENT (EVnn-) function block

2.5 Setting parameters

Table 102: Setting parameters for the EVENT (EVnn-) function

Signal Description

INPUTy Event input y, y=1-16

NAMEy User name of signal connected to input y, y=01-16. String length up to

19 characters.

T_SUPR01 Suppression time for event inputs 1and 2

T_SUPR03 Suppression time for event inputs 3 and 4

T_SUPR05 Suppression time for event inputs 5 and 6

T_SUPR07 Suppression time for event inputs 7 and 8

T_SUPR09 Suppression time for event inputs 9 and 10

T_SUPR11 Suppression time for event inputs 11 and 12

T_SUPR13 Suppression time for event inputs 13 and 14

T_SUPR15 Suppression time for event inputs 15 and 16

PrColnn Protocol for event block nn (nn=01-06). 0: Not used, 1: SPA, 2: LON,

3: SPA+LON, 4: IEC, 5: IEC+SPA, 6: IEC+LON, 7: IEC+LON+SPA.

Protocol for event block nn (nn=07-44). 0: Not used, 1: SPA, 2: LON,

3: SPA+LON

INTERVAL Time setting for cyclic sending of data

BOUND Input signals connected to other terminals on the network, 0: not con-

nected, 1: connected

FuncTEVnn Function type for event block nn (nn=01-06), used for IEC protocol

communication. Only present in blocks EV01-EV06.

InfoNoy Information number for event input y, y=01-16. Used for IEC protocol

communication. Only present in blocks EV01-EV06.

Parameter Range Default Unit Description

T_SUPR01 0.000-60.000

Step: 0.001

0.000 s Suppression time for event input 1 and 3.