ABB | SACE Emax 2
34 | © 2014 ABB | 1SDH000999R0002 - L8569
Ekip Dip protection release | 1 - Operator interface
Ekip Dip protection release
1 - Operator interface
Introduction
The operator interface of the Ekip Dip protection release allows you to:
• Set the parameters relating to the available protections.
• View the status of the release and alarms.
• Connect to the frontal connector to communicate and perform the opening test.
Components of the interface
The Ekip Dip operator interface appears as follows:
Figure 67
The following table provides a description of the components of the interface:
Position Type Description
A
LED
Protection LED L (alarm and trip)
B Protection LED L (prealarm)
C Protection LED S (alarm and trip)
D Protection LED I (trip)
E Protection LED G (alarm and trip)
F Power LED (release powered and on)
G
Protections:
thresholds
Protection L dip-switch (threshold I1)
H Protection S dip-switch (threshold I2)
I Protection I dip-switch (threshold I3)
L Protection G dip-switch (threshold I4)
M
Protections: times
Protection L dip-switch (time t1)
N Protection S dip-switch (time t2 and type of curve)
Or Protection G dip-switch (time t4 and type of curve)
P Settings Neutral and frequency dip-switch
Q
Test
Test pushbutton
R Test connector
IMPORTANT: the figure above refers to a an Ekip DIP, LSIG version. In the case of
Ekip Dip LI or LSI versions, LEDs and dip-switches related only to the protections
present are available.
To Next Page
Loading...
