ABB TB82PH - Page 14

TB82PH ATEX Product Instruction Manual ABB
14 TB82PH-ATEX-EN-A
Note.
Diagnostics is a function valid only with a TBX5
Advantage pH sensors or an AP200 with a
solution ground rod that is connected to Terminal
TB2-4 (green, SOL GND). Diagnostics must be
turned ‘OFF’ if TB5, AP100, AP300, 7650/7660,
ORP or sensors without an integral solution
ground are used.
Caution.
If a programming change has been made,
pressing the Exit to MEASURE key will activate
the SAVE? display (Figure 25). YES and NO
keys will also appear. Press the YES key to save
the changes. If the NO key is pressed any
configuration or programming changes will not be
saved.
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
7.00
PH.GLAS
exit to
MEASURE
ENTER NEXT
pH
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
0.00
4MA.P
T
exit to
MEASURE
ENTER
pH
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
OFF
DIAGS
exit to
MEASURE
ENTER
pH
0.05
SECS
exit to
MEASURE
ENTER
oH
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
7.00
SAFE.M
D
exit to
MEASURE
FAULT
info
ENTER NEXT
pH
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
7.00
Fail.l
o
exit to
MEASURE
FAULT
info
ENTER NEXT
pH
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
7.00
Save
?
exit to
MEASURE YES NO
pH
Figure 19 Figure 20
Figure 21 Figure 22
Figure 25
Figure 24
Figure 23