ABB TPL65-A10 - Hazards During Operation and Maintenance

Operation Manual / TPL65-A10 / -A30
2 Safety / 2.7 Hazards during operation and maintenance
© Copyright 2020 . All rights reserved. HZTL2482_EN Rev.E March 2020
2.7 Hazards during operation and maintenance
Mechanical hazards during operation
During normal operation, no mechanical hazards emanate from the tur-
bocharger if it has been installed properly.
WARNING
Risk of injury
Contact with rotating parts can lead to serious injuries. The turbochar-
ger must never be operated without a filter silencer or an air suction
branch. When the engine is at a standstill, the rotor can turn on its own
because of stack draught.
u Operate the turbocharger in accordance with instructions.
u During maintenance work, secure the rotor against unintentional ro-
tation.
Mechanical hazards when working on the turbocharger
During maintenance work, various risks can occur through the improper
handling of components, through the non-observance of work instruc-
tions, due to inadequate care or as a consequence of insufficient train-
ing.
WARNING
Mechanical hazard
Severe injuries to personnel or fatal accidents can be caused by mech-
anical influences as a consequence of hazardous and inadequate opera-
tional procedures.
u Observe the general rules for occupational safety and prevention of
accidents.
u Ensure workplace safety.
u Only perform operations that are described in this chapter.
u Only perform operations for which you have previously received in-
struction or training.
Page 21 / 117