Operation Manual / TPL65-A10 / -A30
8 Disassembly and assembly / 8.5 Removing cartridge group
© Copyright 2020 . All rights reserved. HZTL2482_EN Rev.E March 2020
u Unplug cable connector (86515) and unscrew speed sensor (86505)
with O-ring (86506).
u Remove the O-ring (42012).
u Remove the three screws (61059) together with their Verbus Ripp®
washers (61058).
u Attach one lifting gear each to the two fins of the bearing casing
provided for this purpose.
u Evenly press off cartridge group by screwing press-off screws
(90900) into the designated holes.
CAUTION
If the rotor blades have insufficient or no clearance, the blades and cas-
ing could be damaged.
u Check that the blades do not rub on the turbine diffuser by rotating
the rotor.
Page 90 / 117
To Next Page
Loading...
