ABB TPL65VA33 - Page 65

Operation Manual / TPL65VA32/33
Maintenance
5
Cleaning the compressor during
operation
5.3
Page 63
© Copyright 2015 ABB. All rights reserved.
September 2015 HZTL2464_EN Revision C
Wet cleaning using external water-pressure vessel (XC3)
Operating state prerequisites for compressor cleaning with XC3
NOTICE
To be able to carry out a satisfactory cleaning process which has been
tested and is recommended by ABB Turbo Systems, the following
prerequisites must be fulfilled:
 Engine load 50 ... 85%
 Start of cleaning cycle in accordance with following description for
wet cleaning operation with XC3.
Compressor wet cleaning procedure with XC3
 It is mandatory to fulfil the operating condition prerequisites before
cleaning compressors with XC3.
 Remove the sealing plug (X).
 Fill the vessel with the required volume of clean water (see the
Table
of cleaning parameters
).
5.3.2
Operating the water
pressure vessel