Designated use
Wire cutter 3HDA000057A8519-001 3-1
Assembly instructions
3 Wire cutter
The wire cutter is an option for the TC 2013 and can be retrofitted at any time. A wire cutter con-
version cut – Article No 3HDA000057A8405 is needed for this purpose.
Note: The wire cutter is already contained in the TSC 2013 (Torch Service Center).
3.1 Designated use
The wire cutter is used for automatic cutting of the welding wire. It only works on combination with
a TC 2013, as it is actuated by the latter.
The wire cutter can be retrofitted on the TC 2013 at any time.
3.2 Technical data
Supply data
Figure 3-1 TC 2013 with wire cutter
Air pressure 5-10bar
Clamping cylinder - diameter 45mm
Stroke 36mm
Clamping force (at 5 bar) 790N
Max. welding wire diameter for cutting d= 1.0mm
d= 1.2mm
Steel
Aluminium
at minimum 5bar air pres-
sure
d= 1.2mm Steel at minimum 6bar air pres-
sure
Weight approx. 1.5kg
Control voltage 24V DC
Compressed air connection G 3/8 inch
Compressed air 6 bar unoiled
To Next Page
Loading...
Need help?
General