ABB VortexMaster FSV430 - 7.2.3 Switching to the Information Level (Operator Menu); 7.2.4 Switching to the Configuration Level (Parameterization)

VortexMaster FSV430, FSV450 SwirlMaster FSS430, FSS450 | CI/FSV/FSS/430/450-EN Rev. G 59
7.2.3 Switching to the information level (operator menu)
On the information level, the operator menu can be used to
display diagnostic information and choose which operator
pages to display.
Process display
1. Open the Operator Menu using .
Operator Menu
Diagnostics
Operator Page 1
Operator Page 2
Back Select
2. Select the desired submenu using / .
3. Confirm the selection with .
Menu Description
… / Operator Menu
Diagnostics Selection of sub-menu "Diagnostics"; see also
chapter "Error messages on the LCD display"
on page 60.
Operator Page 1 ... n Selection of operator page to be displayed.
Autoscroll When Autoscroll is activated, automatic
switching of the operator pages is initiated on
the process screen.
Signal view Selection of submenu "Signal view" (only for
service purposes).
7.2.4 Switching to the configuration level
(parameterization)
The device parameters can be displayed and changed on the
configuration level.
Process display
1. Use to switch to the configuration level.
A
ccess Level
Read Only
Standard
Service
Back Select
2. Select the desired level of access using / .
3. Confirm the selection with .
NOTICE
There are three levels of access. A password can be defined
for level "Standard".
There is no factory default password.
Access Level Description
Read Only All parameters are locked. Parameters are read
only and cannot be modified.
Standard All the parameters can be altered.
Service Only Customer Service has access to the Service
menu.