Abbott 3599 - EPG Procedure Overview; Step-by-Step Procedure

Overview of the EPG Procedure
The following steps provide a general overview of the EPG procedure. Refer to the following secons for
more informaon about each of these steps.
1. Replace the EPG baeries.1.
2. Set up communicaon between the EPG and the clinician programmer and paent controller.2.
3. Implant the leads or extensions.3.
4. Connect the leads or extensions to the mullead trial cable.4.
5. Connect the mullead trial cable to the EPG.5.
6. Test the system.6.
7.
Disconnect the mullead trial cable from the EPG.
7.
8. Disconnect the mullead trial cable from the leads or extensions.8.
9.
Secure the leads or extensions and bandage the lead entry site.
9.
10.
Connect the EPG header to the EPG.
10.
11.
Insert the leads or extensions into the EPG header.
11.
12.
Place the EPG into the pouch and secure to the paent.
12.
13.
Program the system.
13.
12