Abbott 3599 - EPG Indicator Light; Understanding Indicator States; Stimulation Control; Starting and Stopping Stimulation

EPG Indicator Light
The indicator light on the EPG will ash for the following reasons:
▪
When baeries are inserted into the EPG
▪
▪ When a communicaon session with the clinician programmer app or paent controller app is started▪
▪
When the magnet is held for approximately 10 seconds over the EPG (signaling the EPG is ready to pair
▪
with the clinician programmer or paent controller)
NOTE: The EPG indicator light ashes faster when it is ready to pair than when baeries are inserted
or a communicaon session is started.
Starng and Stopping Smulaon
Use the clinician programmer app or the paent controller app to start or stop smulaon. You may also use
the magnet (Model 1210) to start or stop smulaon if Magnet Mode is programmed to On/O or O.
To use the magnet:
1.
Take the keeper bar o the magnet.
1.
18