10 Initial Setup
Inspect Component and Install Battery
Figure A
4. Charge the battery fully before use.
Note: Before use and before giving
batteries to patients, ensure all
batteries are fully charged.
Note: The batteries provided in the
pump kit (carton) are not fully charged
by the manufacturer.
5. Remove the battery cover from the
pump (see Figure A).
6. Insert the battery into the battery
compartment.
a. Match the metal contacts of the
battery and battery compartment
(see Figure B).
b. With the metal contact end inserted
rst, slide the battery into the
compartment (see Figure C).
Note: You will hear a “click” when the
battery is in place.
Figure B
Figure C
To Next Page
Loading...