Ableton Push 3 User Manual

The Clip Button.
When an audio clip is selected, you will see the Loop and Warp
parameters by default.
An Audio Clip in Clip View.
You can press the Loop display button to loop or unloop a clip. When a
clip is looped, you can set the Loop Position, Loop Length, and Start
Offset using the corresponding encoders. When a clip is unlooped, you
can adjust the Start and End positions.
To warp or unwarp a clip, press the display button above Warp.
When Warp is off, the sample is played back at its original recorded
7/29/23, 9:32 AM
Page 143 of 193

Ableton Push 3 Specifications

General

Type	MIDI Controller / Standalone Instrument
Standalone Mode	Yes
Sample Rate	Up to 96 kHz
Bit Depth	24-bit
Pads	64
Display	Full-color
Connectivity	USB, MIDI I/O
Power	external power supply
Storage	Internal SSD
Software	Ableton Live
Compatibility	Ableton Live 11.3 or later
Processor	Intel-based processor (specific model not disclosed)