The Start control sets the absolute position in the sample from which
playback could start, while the End control sets where playback could
end; these parameters define the region of the sample that can be
worked with.
S Start and Length are represented in percentages of the total sample
length enabled by Start and End. For example, hitting a pad after
setting an S Start value of 50% and Length value of 25% will play back
the third quarter (50-75%) of the region between the Start and End
values.
Loop Length determines how much of the available sample (also
determined by the Start and End values) will loop. Loop Fade sets the
crossfade amount for the loop. Note that these two parameters are only
active if Loop is enabled.
You can press Simpler’s upper display button to access the device’s
Edit Mode. When in Edit Mode, you can use the lower display buttons
to select additional pages of parameters and the upper display buttons
to toggle certain settings on or off. Press Simpler’s upper display
button again to exit Edit Mode.
Simpler Options in Edit Mode.
Pressing the Loop On/Off button determines whether or not the sample
will loop when a pad is held down. The Warp as… button adjusts the
warping of the sample between the Start and End values so that it will
play back precisely within the specified number of bars. The values
To Next Page
Loading...