Ableton Push 3 User Manual

Browse and Load Samples in Hot-Swap Mode.
To swap out a sample in a clip on an audio track, press the Session
button to the right of the display to enter Session Screen Mode.
Session Screen Mode.
Use the jog wheel or up and down arrow buttons of the Session D-pad
to navigate to the clip you want to update. Then go to Clip View by
pressing the Clip button to access the sample in the display. You can
then press the Swap button to enter Hot-Swap Mode and change the
sample as needed.
12 Recording and Controlling External
Instruments
Push can be used to control, monitor, and record external synthesizers
and drum machines using a combination of MIDI outputs and audio
inputs. The simplest method of doing this is by using the External
Instrument device so that you can route MIDI and audio to and from
your instruments as needed.
7/29/23, 9:32 AM
Page 158 of 193

Ableton Push 3 Specifications

General

Type	MIDI Controller / Standalone Instrument
Standalone Mode	Yes
Sample Rate	Up to 96 kHz
Bit Depth	24-bit
Pads	64
Display	Full-color
Connectivity	USB, MIDI I/O
Power	external power supply
Storage	Internal SSD
Software	Ableton Live
Compatibility	Ableton Live 11.3 or later
Processor	Intel-based processor (specific model not disclosed)