Shift then press Undo to redo the previously reverted action. In Control
Mode, Undo also applies to actions in Live, even if they were not
performed on Push.
Save – Saves the current state of the Set.
Lock – Hold the Lock button and then press either the Stop Clip, Mute,
or Solo button to lock that action to the lower display buttons. For
example, if you lock the Solo button, you can simply press on a track’s
lower display button to solo it. To unlock an action, press the Lock
button or the button that is locked again.
Stop Clip – Press this button to stop a selected clip from playing. Hold
Stop Clip and press any track’s lower display button to stop the playing
clip in that track. When Stop Clip is held down, the lower display
buttons will be unlit for any tracks that contain a stopped clip.
Mute – Mutes the currently selected track. Hold Mute while pressing
another track’s lower display button to mute that track. Hold Mute while
pressing a Drum Rack pad to mute the pad. Hold Mute while pressing a
step sequencer step to deactivate the step. Hold Mute while pressing a
device’s upper display button to deactivate the device.
Solo – Solos the currently selected track. Hold Solo while pressing
another track’s lower display button to solo that track. Hold Solo while
pressing a Drum Rack pad to solo the pad.
Swing and Tempo Encoder – Sets the tempo for the Set, as well as the
swing amount for quantized and repeated notes. Tap the encoder to
see whether Tempo or Swing is selected. Press the encoder to switch
between Tempo and Swing. When set to Tempo, turning the encoder
adjusts the tempo in increments of one BPM. Hold Shift and turn the
To Next Page
Loading...
Need help?
General
