Ableton Push 3 User Manual

The 16 Velocities layout is similar to the Loop Selector layout in that you
can sequence steps using the Drum Rack pads and sequencer,
however the loop length controls at the bottom right of the pad grid are
replaced with velocity pads.
Press the Layout button to switch to the 16 Velocities layout. In this
mode, the bottom right 16 pads represent 16 different velocities for the
selected Drum Rack pad.
You can play the different velocity pads in real-time. You can also play
them when using the Repeat button to add repeated notes at varying
velocities. Velocity pads can be added to the step sequencer, which will
add notes at the selected velocity to the sequence. You can change the
velocity of steps by holding the corresponding pads in the sequencer
and then choosing one of the velocity pads.
The 16 Velocities Layout.
7/29/23, 9:32 AM
Page 80 of 193

Ableton Push 3 Specifications

General

Type	MIDI Controller / Standalone Instrument
Standalone Mode	Yes
Sample Rate	Up to 96 kHz
Bit Depth	24-bit
Pads	64
Display	Full-color
Connectivity	USB, MIDI I/O
Power	external power supply
Storage	Internal SSD
Software	Ableton Live
Compatibility	Ableton Live 11.3 or later
Processor	Intel-based processor (specific model not disclosed)