13
4.4 Adjusting Wheel Position
The position of the wheel can be adjusted from the right side to the lift side.
1. Use an allen key to remove the allen screws on each side of the controller.
2. Remove the plastic cover from the left side and the wheel from the right.
3. Put the cover and wheel on the opposite side and retighten the screws.
Attention
• The max rotation is about 45° . Attempting to push beyond the max rotation
can cause damage to the transmitter.
4.5 Trims
Trims allow you to change the centre point of the steering, throttle, channel 3 and 4. For example, if a
model that always turns slightly left, the steering trim can be used to correct the problem.
The System has 2 groups of trim switches located behind the steering wheel.
4.6 Power Off
Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Hold the transmitter's power button to turn off the transmitter.
Danger
• Make sure to disconnect the receiver power before turning off the transmitter.
Failure to do so may lead to damage or serious injury.
To Next Page
Loading...
