29
7. RX Setup
7.1 Bind with a receiver
This function enables you to bind the receiver and transmitter so that no other system may interfere with
your model's operation.
To bind the transmitter with a receiver, refer to section "
4.2 Binding
".
7.2 RF std.: ADHDS 2A
This menu allows you to change the communication protocol for the
transmitter. The available protocols are:
• AFHDS
• AFHDS 2
• AFHDS 2A
Note
AFHDS 2A is the latest, most stable and advanced communication
protocol.
When changing mode, a confirmation message will display.
7.3 RX Battery Monitor
This function is used to monitor the receiver battery voltage. Use the supplied battery's user manual to
set the lower and higher voltages, so that the system can monitor battery level effectively.
Setting the voltage alarm sets a custom low battery level alarm.
You can set the following parameters in this menu:
• External sensor: Enables monitoring battery status using an external
sensor.
• Low voltage: Sets your battery's low voltage value which is 4.00V by
default.
• Alarm voltage: Sets the low voltage alarm limit.
• High voltage: Set the maximum voltage when the battery is full. The
default high voltage is 5.00V (Check your battery specifications).
To change settings, touch the desired item and move the wheel to set the new value.
Select the
icon to reset the function.
To Next Page
Loading...
