8. System Settings
8.1 Blacklight Timeout: (Time)
The blacklight timeout function controls how long the system will wait before turning off screens
backlight.
Note:
Backlight time can affect the battery life of your system, the longer the time, the shorter the battery will
last.
To change the backlight time enter the function and select the desired time from the list.
8.2 Backlight: (%)
This function controls the backlight brightness. Note that increasing the brightness will reduce battery life.
To change the backlight brightness, move the wheel at the bottom of the screen to change the percentage.
8.3 System Sound
This function is used to toggle all system sounds, including power-on/power-off sounds, key sounds and
so on. The alarm sound is not included.
To disable the system sounds, uncheck the box by touching it.
8.4 Alarm Sound
This function is used to toggle all alarm sounds.
To disable the alarm sounds, uncheck the box by touching it.
8.5 Auto Power Off
This function powers off the system automaticly after 2 minutes, unless a receiver is connected.
To enable this function, check the box by touching it.
8.6 Screen Calibration
If the touch screen is not functioning correctly, use this function to recalibrate.
To recalibrate once inside the function touch the centre of the crosses as they
appear on the screen. The system will exit the function once calibration is
complete.
Note:
It is recommended that you use the supplied stylus to calibrate the screen.
8.7 Units
This function is used to change between Metric and Imperial mesurement systems.
8.8 Language
The system can choose between 3 languages:
• English
• French
• Greman
Select the
icon to return to the previous menu.
8.9 Firmware Update
The internal software of the transmitter can be updated using the USB interface connected via a PC
computer. Once this function is activated, all functions of the transmitter stop. To avoid any loss of control
of the vehicle, turn its receiver off before entering this mode. A confirmation is requested.
When the firmware is updating, never disconnect the USB cable or remove the battery or the transmitter
will become unusable.
This function can be helpful only when connected with computer. Follow the steps as shown below:
1. Download and open the newest official software.
2. Connect a transmitter with a computer by USB cable.
3. Enter transmitter firmware upgrade menu and press OK to complete.
8.10 Factory Reset
Resets the system to its factory settings. The system will display a prompt asking for confirmation. Select
"Yes" to reset.
8.11 About CR4TS
This menu contains: Product name, Firmware version, Hardware version and transmitter ID.
To Next Page
Loading...
