Make the settings for the base station here.
The changes in the settings are only saved
after leaving the menu.
The Admin password allows access to the
advanced settings and enables / disables
the camera recordings.
The default password is "123456" and
must be changed the first time the
settings are accessed.
If you have forgotten your password, you
can reset the base station by pressing the
reset button for about 5 seconds.
Attention:
All settings including the network
connection will be lost.
The security code is used to set up the
base station in the app.
The default code is "123456" and must be
changed during the initial installation.
If you have forgotten your security code,
you can reset the base station by pressing
the reset button for about 5 seconds.
Attention:
All settings including the network
connection will be lost.
To Next Page
