clean the ice box and use it again after an extended period of inactivity. Typically, it is convenient
to sanitize the storage bin after the ice making system has been cleaned and the storage bin is
empty.
1. Disconnect power to the unit.
2. Open the door and with a clean cloth, wipe the inside with a sanitizing solution made from
28g of household bleach or chlorine and 7.5L of hot water (95
°
F to 115
°
F).
3. Rinse thoroughly with clean water. Wastewater will be drained through the drain.
4. Reconnect the power to the device.
Ice scoops should be cleaned regularly. Wash like any other food container.
Ice making parts cleaning
During use, please clean the main system of the ice machine regularly (as shown in Figure 9).
1. Repeat the above steps to clean the water tank and other internal parts of the device.
2. Paying attention to the water distribution pipe on the evaporator, when the compressor and
water pump are running normally, if there is no water flowing from the water distribution
pipe, or the water flow is very small, please drain the water distribution pipe cleanly. Clean
each of the small holes on the manifold shown in the picture below, making sure nothing is
blocking each of the holes, and put them back in place.
3. When there are ice cubes on the surface of the evaporator, but it is not easy to fall, do not
use mechanical means to forcibly remove them; simply press the "ON/OFF" button for more
than 5 seconds and the device will enter the ice melting process. After a while, the large ice
cubes will fall. Then, turn off the unit, unplug the power cord, and clean the surface of the
evaporator.
4. Cleaning of the water tank and full ice detection board (as shown in Figure 10). The water
tank and full ice detection plate are very important to keep the ice cubes hygienic. Place a
mixture of neutral detergent and water in a clean water nozzle and spray onto all interior
surfaces of the water tank and ice detection plate. Wipe these surfaces as much as possible
with a clean cloth. Then, spray the surface with clean water and wipe with a clean dry cloth.
solvent
To Next Page
Loading...