18
Installation
To install the monitor on your host system, please follow the steps below:
Steps
1 Connect the video cable
A：Make sure both the monitor and computer are switched off.
B：Connect the VGA video cable to the computer.
2 Connect the power cord
Connect the power cord to the monitor, then to a properly grounded AC outlet.
3 Turn on the monitor and computer
Turn on the monitor first, then the computer. This sequence is very important.
4 If the monitor does not function properly, please refer to the troubleshooting section to diagnose the problem.
http://www.wjel.net
To Next Page
Loading...
